CNC Bender v12-20111229

v12-20111229 Back to CNC Bender Software Updates

REPAIR - Pressure Die Interference Zone Collision Message

The pressure die interference logic would stop the bending with a collision fault if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis. This has been resolved with this version. If the PDA is a servo axis, then the potential for collision is ignored.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands