CNC Bender v12-20111229

v12-20111229 Back to CNC Bender Software Updates

REPAIR - Pressure Die Interference Zone Collision Logic Change

ISSUE: The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis. THE REPAIRED LOGIC: Now if the PDA is a servo axis and GEARING is switched on in the bend arm servo module, then the potential for collision is ignored . This will assume that the pressure die assist is geared to the bend axis and is moving forward with the bend arm. Note that it is possible for a collision to still occur if the radius value is set incorrectly in the tool page, or the real-time variable gearing for the PDA is set low enough to allow the carriage to catch up to the PDA.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands