VTube-LASER v1.77.3

Revision 1.77.3 Back to VTube-STEP Back to VTube Software Updates Back to VTube-LASER

ENHANCED: View Orientation Control Redesigned

The View Orientation Control has new choices with graphics icons of each axes orientation. You can click on the button or the image to find a new orientation.

NEW: Diameter Model End Lengths Change Based on New "End Adjustment Length" Values in Part Setup

When the A-End or B-End Adjustment Lengths change, then the diameter model lengths change automatically at the next redraw. This does not change the centerline end point location.

REPAIR: The Cut Length Calculation with Non Zero End Adjustments Is Repaired

The End Length Adjustments values are no longer doubled in the Cut Length calculation.

Other Pages

• Back to the VTube page