Benderlink for SolidWorks

Benderlink for Solid Works software is designed to convert from Solid Works to bender data then to connect Solid Works workstations to SVNET-based benders.

If a measuring center arm is setup to sketch a 3D centerline of a measured tube shape, then Benderlink will help you reverse-engineer tube shapes, and assist in correcting the bender's data.

Features

The main features of this software:

1. - Read tube data from Solid Works
2. - Convert the tube data to bender data
3. - Save / Recall the bender data
4. - Send new nominal data to benders that support SVNET protocol.
5. - With a measureing center: Make and send correction data to benders that support the SVNET protocol.
6. With a measuring center: Reverse-engineer tube shapes

http://advancedtubular.com/blink_sw/help_html/clip0003.jpg

The correction feature is peformed by measuring a tube with ROMER / FARO arm, using this data to create a tube centerline in Solid Works, then allow Benderlink to compare this inspected data with the MASTER data.

[1] Read the online help

--Mcone 13:37, 28 July 2006 (EDT)