CNC Bender v12-20120830

v12-20120830 Back to CNC Bender Software Updates To download the update see the support page.

Enhanced: Autoloader Manual Page Redesign

CNC Bender can now make the TUBE ROTATE and SEAM DETECT buttons invisible. See these two screens:


This next screen shows the two buttons removed from the screen:

Control the visibility of buttons with new low level options:

NEW: Added new Processlists for Autoloader Buttons

Three new process lists were added: autoloader_home.cncprocesslist autoloader_liftup.cncprocesslist autoloader_liftdown.cncprocesslist These three processlists control the jogging that occurs behind the Autoloader Home button Lift Up button Lift Down button Rules: The processlists do not need to exist - however, the buttons in the manual page will do nothing unless commands are inside the processlists. No block logic is accepted ([IF], etc.) in these processlists. Parameters are allowed - like "= cto:5000", etc.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands