How to Setup for Supravision Network Protocol

How to setup the SVNET protocol with Benderlink for EL. Back to Benderlink for Eaton Leonard

Step 1: Enter the Benderlink Network

Open the Tools > Configure Benderlink Network Menu

Step 2: Enter the Benderlink Network

Press the Bender Network tab, then select the bender you want to edit (or add one), then press "Edit".

Step 3: Setup the Bender Communication Parameters

• Each bender number must be unique.
• The name will display in the user interface of Benderlink.
• The COM port is the port number assigned to communicate with this bender.
• Press OK.

Step 4: Switch to the Measuring Center Name Tab Menu

Set the name of the measuring center to one of the types that uses the Supravision Network protocol.

Step 5: Switch to the Measuring Center Protocol Tab Menu

Set the name of the measuring center protocol to "Supravision Network".

Step 6: Switch to the Supravision Tab Menu

• Set the monitor frequency from 2 to 5 seconds
• Set the max benders to scan (set to your highest bender number)
• Set the Supravision Network path that Supravision uses to drop SVNET files.
• Enable the Monitor for SV Commands checkbox