VTube-LASER Videos

See a complete list of VTube-LASER videos on this page. Back to the Main VTube-LASER web page Back to VTube-LASER Knowledgebase Page

Version 1.80 - December 8, 2012

Video Topic: Effective highly reflective aluminum scannning

This is a proof-of-concept video for a 1/2" highly reflective aluminum tube. The goal is demonstrate repeatability better than 300 microns. The result was a range from 80 to 180 microns (0.003 to 0.007") maximum deviation. This video shows the best way to scan a highly reflective tube end - and how to be sure the scan is good.

View on YouTube View MP4

Version 1.80 - November 23, 2012

How to extract a tube centerline of demo part 2 with VTube-STEP version 1.80. Note that this part has a 180 degree bend - which requires special steps for import anc calculation.

View on YouTube View MP4

Version 1.76.4 - May 15, 2012

How to measure a straight tube.	View on YouTube View MP4
How to use Measured tube data to create Master tube data.	View on YouTube View MP4

Version 1.76.3 - April 2, 2012

How to setup the Scanner Control to measuring tubes with the laser probe.

View on YouTube View MP4

Version 1.76 - March 15, 2012

Unbending a tube with coping at either end. (Pro and LASER License Level)

View on YouTube View MP4

Version 1.75 - February 2012

• View on YouTube - Measuring a small 8mm tube that bends back on itself
• Download MP4 - Measuring a small 8mm tube that bends back on itself

• View on YouTube - Measuring a highly deformed 6 inch tube for hydroforming
• Download MP4 - Measuring a highly deformed 6 inch tube for hydroforming

• View on YouTube - Reverse engineering a highly reflective part with a 180 degree bend
• Download MP4 - Reverse engineering a highly reflective part with a 180 degree bend

• View on YouTube - How to compare two Supravision project files in VTube-LASER
• Download MP4 - How to compare two Supravision project files in VTube-LASER

• View on YouTube - STEP Mode Solid Model Import of Large Diameter Tube
• Download MP4 - STEP Mode Solid Model Import of Large Diameter Tube

• View on YouTube - How to demonstrate VTube-LASER importing a CAD model.
• Download MP4 - How to demonstrate VTube-LASER importing a CAD model.

• View on YouTube - How to demonstrate measuring the VTube-LASER demo tube.
• Download MP4 - How to demonstrate measuring the VTube-LASER demo tube.

Older Versions

• v1.73 Measuring HVAC parts with 180 degree bends
• v1.57 Reverse Engineering a Tube
• v1.57 Recall MASTER Bender Data from Benders
• v1.53 Reverse Engineering SPEED TEST Video
• Measure 1/2" tube
• Start a new 1/4" tube project with master data

Other Pages

• Back to VTube-LASER