CNC Bender v12-20130710

v12-20130710 Back to CNC Bender Software Updates

NEW: :Skip Step Tolerance value in Main.axilist

The c:\cnc\config\axis\mail.axislist file contains a new value called "Skip Step Tolerance". This is a floating point value that is only considered positive. As of this version, the value is only effective for the bend axis. If the bend arm is within this value, then it will consider itself as being home (at zero), and will skip the move to zero to save time. The default value is 0.25. Warning: If this value is set too high, then the bend arm may not return home even when it is supposed to.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands