CNC Bender v12-20130805

v12-20130805 Back to CNC Bender Software Updates

See CNC Bender Customer Service Page for an update.

NEW: Swing-away Inside Wiper Logic

The new logic ensures that the swing-away inside wiper die swings away properly for a one bend part. The swing-away inside wiper will no longer move in before the carriage moves to the START position. It will only move in after the motion to the start position. If the START position is inside the wiper die zone, then the wiper die will swing in only if the next motion is to unchuck and move back out of the zone (for example on a one bend part).

NEW: PDA Forward Now Stops During Cycle Hold Button Press

The PDA motion in a bend stops moving forward if the CYCLE HOLD button is pressed. (It would stop when the safety mat was stepped on - but not when the CYCLE HOLD button was pressed.)

Other Changes

Manual button presses when in CYCLE HOLD mode no longer clear the command with the "Use CYCLE START" message. The AUTO button no longer disables when in CYCLE HOLD. As with the previous version, COMDEFS can ignore CYCLE HOLD. For example, the Clamp and PD open commands can programmed to ignore the CYCLE HOLD state - and open even in CYCLE HOLD.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands