CNC Bender v12.1.1

v12.1 - August 14, 2013 Back to CNC Bender Software Updates See CNC Bender Customer Service Page for an update.

FIX: FRB Clear Part Fixed

CNC Bender would save parts after a FRB clear by default in the c:\cnc\config folder. This was repaired so that it saves inside the the correct parts folder.

NEW: Processor Now Checks to See if Inputs are Internal

CNC Processor can now check if an input is an internal input that is not connected to a physical input. This is used for setting and reading states inside the Processor without using actual physical I/O.

FIX: CNC Bender Benderlink Fix with Laservision

CNC Bender Benderlink would sometimes return an out-of-bounds error after receiving Laservision data. This was related to setting the first straight adjustment value to zero. It has been resolved.

ENHANCED: CNC Bender Benderlink Can Emulated Hyprex Laservision

Hyprex Laservision

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands