VTube-LASER - End Scan Diameter Qualification Tolerance
From ATTWiki
|
|
|
How the Tolerance Works
|
The End Scan tolerance allows VTube-LASER to control which points are accepted as potential end-scan points based on how far the points are from the A-End and B-End Diameter values. The image above illustrates a tolerance of 10 millimeters. Any end scan points within that region will be qualified. See the orange points in image. The red points are outside the tolerance, so they are rejected. |
How to Set the Tolerance
| You can set the tolerance in two places in VTube. One place is in the System Options / Measure 2 menu. |
|
| The second place to edit the value is in the VTube-LASER Measure Setup menu's "Other" tab menu. |
|
Other End-Scan Information
|
Other Pages
- Back to VTube-LASER
