VTube-STEP v1.84

Revision 1.84 Back to VTube-STEP Back to VTube-STEP Revisions Back to VTube Software Updates (for LASER Mode) Back to VTube-LASER

• See VTube-STEP Customer Support Page to download the latest version.

NEW: Export to Alpine M4 MBF Data File

VTube can now export XYZ data to an Alpine M4 data file. This feature sends XYZ coordinates for setup. The extended export feature lets you set the radius level before sending the data to the bender.

ENHANCED: SolidWorks Builder

The SolidWorks tube builder can now: Build constrained end and intersection points in 3DSketch. Build constrained centerline geometry in 3DSketch.

Other Changes

VTube now always reports reduced arc lengths compensated for elongation if the elongation percentage is greater than 0. (It used to always report the theoretical value without elongation.) VTube no longer refreshes the tube model on the screen when a project is saved. This saves significant amount of time for large models. The model refresh time is optimized significantly - especially when the point labels are switched on. Repairs were made to the Language Editor. Internal were made repairs to the Part Setup grid. Corrections were made to field types. Click on column cell 1 of the Default Radius field to show the Radius Table.

Other

• Back to VTube-STEP
• Back to VTube Software Updates (for LASER Mode)
• Back to VTube-LASER