CNC Bender v12.7

v12.4 - January 20, 2014 Back to CNC Bender Software Updates See CNC Bender Customer Service Page for an update.

ENHANCED: Load and Start Positions with Bend Arm Motion

CNC Bender PreBend has a new option called "Arm to Home Mode" that controls when the bend arm returns home before bending begins. The goal is optimization of the cycle. These are the choices: 1: Before Move to Load 2: During Move to Load 3: After Move to Load 4: After Chuck Close 5: During Move to Start 6: After Move to Start Use this in conjunction with the PostBend Release command where you can turn off the bend arm return during release.

ENHANCED: Extended Timing Control for Servo Modules

Other Changes

The HAND BENDER MODE of CNC Bender is enhanced to allow for Bending without the Feed axis following. This is helpful for applications where the last bend will pull the chuck into the pressure die or inside wiper die.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands