CNC Bender v12.8

v12.8 - February 1, 2014 Back to CNC Bender Software Updates See CNC Bender Customer Service Page for an update.

FIXED: Teach Mode and Custom Commands Issue Solved

Custom commands can be entered after every bend in the FRB page. SMT discovered a that FEED and ROTATE commands would not be completed properly when coming out of a custom move. For example, the ROTATE was programmed at 90 degrees. The custom move is 89 degrees - so the finish up command should be set to 1 degree to come to the full 90. However, the finish-up command would go to 90. This problem occurred on benders where the ROTATE axis is set to a non-standard machine axis 3 - because the machine axis number was hard coded into the process list builder. Process list builder now has logic that anticipates that the machine axis number for any motion actuator can change depending on the application.

ENHANCED: Load and Start Positions with Bend Arm Motion Option (in Pre Bend)

The Option List panels now clear if all options are placed in the tool box.

Other Changes

New version number set in all executables: 12.8

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands