VTube End Length Offsets

Back to VTube-LASER Back to VTube-STEP

• It is possible to use end length adjustments to adjust the material length of the tube without moving the actual end point.
  
  
• Use this to add material for end forms and other operations that require extra material.
  
  
• These offsets will be added into the calculated Cut Length in the Part Setup menu.
  
  

How End LENGTH Offsets Work in VTube

End Length Offsets Add or Subtract Material Length The end offsets in the Part Setup menu add or subtract material the ends in real-time. This is the starting tube with no A End or B End offsets.

Entering a Positive Length Offset in the Part Setup Menu We can change the B End Offset in the Part Setup menu like this: Then we press F2 to refresh the graphics, and B end is made longer - without moving the end point.

Using Transparency to Show the Effect Here is the result with transparency increased to 0.75:

Entering a Negative Length Offset in the Part Setup Menu You can also subtract material from an end by using a negative value like this: Then press F2 to refresh the graphics, and B end material is made shorter without moving the end point.

Other Pages

• Back to VTube-LASER