VTube-LASER v2.1.2

Revision 2.1.2 Back to VTube-STEP Back to VTube-STEP Revisions Back to VTube Software Updates (for LASER Mode) Back to VTube-LASER See VTube-LASER Customer Support Page to download the latest version.

ENHANCED: Improved Graphics Engine

Perspective projection is much improved. Point labels drawing has improved logic and is much faster.

NEW: Winton WMC Bender Data File Setup Window

The new window allows VTube users to edit the data inside a Winton WMC file before exporting or adjusting a WMC file.

NEW: SUPRAVISION Network Engine Now Handles Benders with Inverted Rotations

The Supravision network engine now allows for rotations to be inverted for benders that have rotations that move in the opposite direction to VTube.

ENHANCED: CSM and ALPINE File Data Transfer Tested and Improved

The CSM and Alpine conversions now correctly invert the rotation value in both M3 and M4 controls - since they move in the opposite direction from VTube rotations. Other adjustments and fixes to the conversion were tested with both styles of bender controls. When VTube sends corrections to the M4 controls, it now changes the adjustment values rather than the nominal values in the YBC page.

Other Changes

• The VTube configuration file location was changed to the more standard "c:\ProgramData\VTube" location.
  
  
• The installation performs a better job of setting up the configuration file location.
  
  
• The Supravision network engine has been enhanced to handle data files that don't follow the Supravison spec perfectly.
  
  
• We fixed a ball probe measurement issue where VTube would sometimes not always take in single points from the FARO driver. This issue created problems with measuring cut planes too. If you measured cut planes, and still couldn't get the cut plane to work properly, then it was probably due to this issue.
  
  
  

Other

• Back to VTube-STEP
• Back to VTube Software Updates (for LASER Mode)
• Back to VTube-LASER
• See VTube Language Editor