CNC Bender v14.9

v14.9 - September 1, 2015 Back to CNC Bender Software Updates See CNC Bender Customer Service Page for an update.

NEW: Added Mandrel Support

New automatic mandrel is added to CNC Processor. New options for this feature are: Low Level Options Command Name - Mandrel Support Up: This is the COMDEF name for sending the mandrel support UP. CNC Bender uses this in the manual page. Command Name - Mandrel Support Down: This is the COMDEF name for sending the mandrel support DOWN. CNC Bender uses this in the manual page. CIO Name - Mandrel Support Output Down: This is the CIO output for sending the mandrel support down. CNC Processor uses this to send the Mandrel support down automatically. CIO Name - Mandrel Support Output Up: This is the CIO output for sending the mandrel support up. CNC Processor uses this to send the Mandrel support up automatically. CIO Name - Mandrel Support Input Down: This is the CIO input for checking if the mandrel support is down. CNC Processor uses this, if present, to stop the AUTO process if the Mandrel support does not signals down when it should. Mandrel Support Input Check Pause Timer - This is a millisecond pause timer that pauses before checking for the mandrel down input active. The maximum value is 1000 milliseconds. Mandrel Support Buttons Hide - This allows you to hide the manual page buttons in CNC Bender.

ENHANCED: TEST BEND Pressure Die Motion

The Pressure Die open and close in the TEST BEND page can now be used even no matter where the CLAMP die is.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands