Data Conversion Rules for Benderlink for Chiyoda/KEINS

Data Conversion Rules Back to Benderlink for Chiyoda Back to Benderlink for KEINS

To Send NEW data to a KEINS or Chiyoda Bender from the Measuring Center

1. To send NEW data to a KEINS or Chiyoda bender from a measuring center through Benderlink, it is important to clear the FPB data to one bend and set all the FPB values to ZERO. This includes the adjustment values.
   
   
2. In this case, the number of bend rows will be increased to match the measuring center data.
   
   
3. All data will be replaced.
   
   

To Send ADJUSTMENTS to a KEINS or Chiyoda Bender from the Measuring Center

1. If there are non-ZERO values in any of the FPB cells, or there is more than one bend row, then Benderlink will always MERGE new data to the existing rows. This setup is appropriate for corrections loops.
   
   
2. This means that no new rows will be created if the incoming data has more bends than the existing bend count.

OTHER PAGES

• Back to Benderlink for Chiyoda Page

• Back to Benderlink for KEINS Page

• Benderlink Page

• Benderlink for Chiyoda FAQ

• About Chiyoda - See this page for control version information.