CNC Bender v14.9-r8

v14.9-r8 - January 11, 2015 Back to CNC Bender Software Updates See CNC Bender Customer Service Page for an update.

FIX: Handling Slightly Negative Numbers for Motion Commands

This fixes a problem with handling motion command values in the range of GREATER than -1 and LESS than 0 in the AUTOBUILD process.

For example sending the rotate command to -0.1 degrees would not compile in previous versions of v14.9

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands