CRIPPA benders are built in Italy and marketed worldwide. Customers report that they like these benders very much. They are often all electric with all actuators servo-controlled.
|
|
CRIPPA UII Control software
|
The CRIPPA Windows software allows for complete programming of bender setup.
|
|
VTube-LASER Support for Crippa Bender Setup and Corrections
|
VTube-LASER communicates with the CRIPPA UII software using the Supravision Network protocol.
Communications are fully bidirectional - you can send and recall data.
It is possible to send new part data to the Crippa, and to correct existing parts easily with the Crippa communications.
(Crippa added this capability in late 2014.)
|
|
A Customer who uses VTube-LASER with a CRIPPA Bender
|
Aerospace Welding, Inc., is a Montreal-based fully-certified fabrication company for major aerospace companies.
They use VTube-LASER running on a FARO arm to setup and correct an all electric CRIPPA bender.
During their initial training sessions, the customer bent a part on the bender based on the nominal setup data that was entered into VTube-LASER, then transferred to the bender.
The operator used VTube-LASER on a FARO arm to measure and prove that the part had a maximum deviation of 0.060" of deviation along the centerline profile. The centerline profile tolerance, per the print, was from 0.030 inches up to 0.050 inches for this aerospace part - so it was necessary to send a correction to the bender.
The first correction reduced the profile deviations so that only one deviation peaked at 0.012 inches. All the other deviations where half that value or better. The End-A length deviation was literally 0.000 inches, and the bending technician trimmed the other end using the "End-B Trim" value in the VTube-LASER inspection page. He remeasured the final part which was confirmed to be completely inside tolerance.
Aerospace Welding is very happy with this system.
Contact Information
Nino Buttino, Directeur Commercial (Commercial Director)
Aerospace Welding, Inc.
Phone: (450) 435-9210 x2223
890 Blvd. Michelle-Bohec
Blainville, QC J7C 5E2
Canada
|
|
VTube-STEP Support for CRIPPA Bender SPF Files
|
VTube-STEP can export Crippa export capability allows for easy export to Crippa UII software. The format is a text file that is compatible with most Crippa benders that were released in early 2012 and on.
|
|
Contact Information
CRIPPA USA Distributor
Chris Harrison
Tube Process Technology LLC
4343 SKUSA DR
BRIGHTON, MI 48116
Phone (810) 599-1972
E-Mail: [email protected]
Other Pages
