CNC Bender v14.9-r10

v14.9-r10 - March 10, 2015 Back to CNC Bender Software Updates See CNC Bender Customer Service Page for an update.

ENHANCEMENT: Cross Slide Check

In previous versions of CNC Bender, the internal logic would not allow the manual page jog close of either PRESSURE die or CLAMP die if the Cross Slide INPUT for AWAY from die (or in the home position) was active. This has been changed so that CNC Bender now only examines the Cross Slide INPUT for ADVANCED or IN the die active. This allows for locking the carriage cross slide for little or no movement - with both prox switched active at the same time - and still close the dies.

ENHANCEMENT: SUPRAVISION Communications

Previous versions of CNC Bender would send Supravision data with XYZ values even if the XYZ values had not been setup (and were all zeros). This caused ROMER software products to refuse the incoming data and display an error. This release of CNC Bender will automatically remove the XYZ data if they are all zeros. This satisfies the ROMER software rules.

ENHANCED: Jog Halt

When a direct axis jog button is released, the motion will stop much faster than in previous versions.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands