VTube-LASER v2.5

Revision 2.5

Back to VTube-LASER
Back to VTube Software Updates (for LASER Mode)
See also VTube-STEP
See also VTube-STEP Revisions
See VTube-LASER Customer Support Page to download the latest version.

IMPROVED: Best Fit - Automatic End Weight Version 2 - Tighter and Faster Alignments

We're always happy to give you a feature that does more - and does it FASTER than before. This is one of those features.

Version 2 of the Best Fit engine aligns tube shapes faster and tighter than the original. For example, a 25 second alignment is now made in 20 seconds, and a 0.013" average deviation might drop to an average of 0.009".

Version 1 was very good at tight alignments as the measured tube shape started to conform more to the master tube shape. However, version 2 creates a tighter fit faster - and handles shapes that are further from the master shape much better than version 1.

The two alignments shown here are the results of the two versions of alignments in version 2.5 using the same master/measured data. When qualifications are on the edge of the tolerance, then this extra tight alignment can pay dividends.

Not only is the alignment tighter, but Version 2 has extra logic that gives more emphasis to increasing the number of TANGENT and MIDPOINT CELLS that are within tolerance. It also considers the number of MIDPOINTS in tolerance. Version 1 only considers the tangent points. All of this creates tighter logic for alignment.

Note: We understand that some customers are very careful when approving new part alignment algorithms - so we were careful to leave the original version Best Fit option in the VTube Inspection Results menu to give you time to learn to trust and use Best Fit version 2.