VTube-LASER FARO Arm Riser

What is a Riser?

For tube measuring, customers often like a simple system that makes tube measuring easier by lifting the arm off the table. The riser is a simple device that raises the arm.
STEP 2 Press Probe Setup and Calibration.
STEP 3 Select the correct ball probe then press OK. This step will cause the FARO driver to report back to VTube the new probe. The FARO driver should always remember the last ball probe that you set to "Current Probe" in the pulldown box. This is true even if you shutdown VTube-LASER and the FARO arm.
STEP 4 Press the Close button in the FARO Arm Utilities window.
STEP 5 Observe that the new ball probe selection will appear in the Arm grid.