Revision: Benderlink for EL v4-20070619
Contents |
REPAIRED: FLOAT POINT CONVERSION IN VERY SMALL NUMBERS
BACKGROUND
AICON technicians discovered problems with the conversion of very small numbers between Benderlink and Eaton Leonard controls.
RESOLUTION
We carefully examined the values from a Premier control starting at 0.001 then moving upward and discovered the problem. We are confident that the problem is completely resolved and proved through a test devised by AICON.
REPAIRED: CONVERSION
The Die Clearance is linear and was not converting between the two units. This has been fixed.
ENHANCED: EDIT FLOAT VALUES
All of the edit boxes for the SETUP and EXTENDED SETUP values will no longer allow any character except those used to form numbers.
|
RECALL 2 Bends |
Method: Ethernet Cable with Benderlink Module |
|
RECALL 63 Bends |
Method: Ethernet Cable with Benderlink Module |
|
SEND 2 Bends |
Method: Ethernet Cable with Benderlink Module |
|
SEND 63 Bends |
Method: Ethernet Cable with Benderlink Module |
(Speeds for wireless (WiFi) are usually slower than the speeds shown above.)
MULTIPLE SKINS
BACKGROUND
As of Benderlink for EL v4, we've been adding skins the interface of Benderlink. Customers have responded positively regarding the new look, so we are now sending the setup file of this version of Benderlink with multiple skins that can be changed by operators.
HOW TO CHANGE
Click on the caption icon for the form (in the upper left corner) to access the skins menu. The default skin is BlueGauze.
PERSISTENCE
The skins are persistent through storage in the Windows Registry.
