Safe Mode Motion Auto Recovery
Contents |
Basic Description
CNC Bender motion can recover and complete any controlled motion from any "Safe Mode Cycle Hold" state to a Cycle Start condition.
This includes Auto Mode motion, Step Mode motion, and Controlled Jog motion.
How It Works
If an operator steps on the mat in the middle of any motion, the SMT bender comes to a zero-energy state immediately. All axes are disabled. When the operator presses Cycle Start, then the bender will recover from the disabled state, re-enable the axes, calculate the remaining motion, and then complete all motion.
All Processlist Types
This is true of the primary and all secondary processlists running at the same time.
CNC Bender Upgrade
This feature is available on CNC Bender software versions 10-20070425 and higher. The feature is available for installation on older systems, but requires that the older system electronics be upgraded. Please contact either SMT or Advanced Tubular for more information about how to upgrade your benders to include this feature.
