Revision 2.8.1

Original Release Date: May 8, 2017
Latest Build: 70 - May 6, 2017

Back to VTube-LASER
Back to VTube Software Updates (for LASER Mode)
Download in updates the VTube-LASER Support Page

BUILD 70 - May 6, 2017

NEW: END OFFSET MODEL Feature

This adds a second model of the end point before it is offset.

This allows you to visually confirm that the offset point (orange) is based on the correct datum point (yellow) when a Measured offste is used, and/or a ball probe is used on the end.

In the top image on the right, the yellow ball represents the middle of the ball probe. The orange ball is the projected end point based on the compensation toward the end.

When the two points are within 0.1 mm (0.0039 inches), then VTube only draws the final orange ball.