How To Export VTube Reports To A Network Path

How to Export VTube Reports To A Network Path

Sample Print

This is a sample print with the design intent of checking the width and the height. You can use the VTube-LASER DATUM feature to get to these dimensions.

The diameter of this part is 1.25 inches. You will need to find the X centerline dimension by subtracting 1.25 from 5.5. So - the X dimension should be 5.5 - 1.25 = 4.25.

The Y dimension will be 13, since it is already dimensioned the way VTube-LASER will dimension a part.

Set the Datum

It's necessary to set the datum using the Datum tab in the MASTER DATA menu.

It may also be necessary to rotate the master tube into the an orientation that is similar to the print. In this case, we used the Transform feature to rotate the master tube so that the first leg is aligned to the Y axis.

Datum Reports

After a measure and alignment, use one of the Datum reports in the report menu to show the dimensions.

In this example, the two X values show the dimensions that correspond to the 5.5 dimension.