VTube-STEP v2.9.16

Revision 2.9.16 Release Date: October 19, 2018 Build: 2 Back to VTube-STEP Back to VTube-STEP Updates See also VTube-LASER Updates See also to VTube-LASER Download in updates the VTube-STEP Support Page

FIX - IMPORTANT UPDATE for IMPORTING 180-DEGREE BENDS

If you import models with 180-degree bends, then you will use the Split Bend COLLECTION feature in VTube-STEP. We discovered a problem that could cause the centerline of the Split Bend construction to be short by 0.020 inches (0.5 mm). If you use the Split Bend logic in VTube, then this update is critical for you because it addresses an issue we discovered during some research into Split Bend measuring issues with a customer.

NEW - SUPRAVISION BATCH IMPORT - NOW USES YOUR DEFAULT SETUP TO BUILD PROJECT FILES

The Supravision batch import can import any number of Supravision files at one time - building huge numbers of VTube project files in minutes. We added the ability for this batch engine to automatically use your current project default when importing the data.

NEW - VTUBE-STEP NOW IMPORTS AUTODESK INVENTOR TUBE XYZ FILES

Autodesk Inventor can create text files that contain the centerline XYZ data for a tube. VTube-STEP can now import these files.

OTHER CHANGES

Fix - "Reset Point Labels" - The point labels no longer revert to the previous state if you save the project after a point label reset.

Other Pages

• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.