CNC Bender v10-20070914

CNC Bender User Interface for ProControl

IMPROVED: Improved Auto Build during AUTO MODE

Explanation

• CNC Bender automatically switches from Auto Mode to Manual Mode during the Auto Build process.
• There was a possibility that the process list builder would attempt to build a process list even though CNC Bender had not switched to MANUAL mode.
• This situation would cause errors or lockups.
  
  

Solution To Issue

This version patiently waits for CNC Processor to switch to MANUAL mode before attempting to build the process list.

IMPROVED: MASTER Folder Protected from Non-Password Part Load or Save

Explanation

• CNC Bender would allow a user to switch from the PARTS folder to the MASTER folder while loading parts, thus bypassing the password entry box.

Solution To Issue

This version will no longer allow access to the MASTER folder from the PARTS LOAD or SAVE dialogs.

How to UPGRADE

If your operator station contains one of the versions listed below, then they can be upgraded through simple self-installation:

• CNC Bender v10-20070726b
• CNC Bender v10-20070803
• CNC Bender v10-20070828

Please contact Advanced Tubular Technologies for upgrade information.