VTube-LASER Leapfrog

Back to VTube-LASER See also Calibration-Leapfrog-Move Targets

Leapfrog the Arm Over the Tube

As of version 1.91 (June 30, 2014), VTube-LASER can leapfrog the arm over the tube in the middle of any measurement. In order to accurately leapfrog the arm over the tube, it is necessary to pause the regular measurement and measure 3 more more points in space using the ball probe before and after the leap or move. Then, after the leap, the arm measures the same points in the same order. Any number leaps can be combined to measure any distance.

Start a Leapfrog Measurement

Press the Leap button in the guide box at any time during a measurement.

The Steps for Leapfrog

Place at least 3 targets as far from the arm as possible in the direction you want to leap. Press the LEAP button in the guide window on the left. Measure the targets with the ball probe. Press the green button to measure each target. Press the red button to finish the initial measure. Without moving the targets or the tube, leap the arm over the targets to a new position. Measure the targets with the ball probe. Press the green button to measure each target. Press the red button to finish the measure. The leap is complete. Continue measuring where you left off before.

Leapfrog Kit - Magnetic or Plate

This is the magnetic leapfrog kit that we offer on our store. Each magnet has a conical seat attached to a magnet that can be placed anywhere for leapfrogging
This is a leapfrog plate that we offer on our store. The plate has three numbered conical seats.

Other Pages

• Back to VTube-LASER
• See also Calibration-Leapfrog-Move Targets
• Purchase the targets at the store.