Benderlink for SolidWorks
Benderlink for Solid Works software is designed to convert from Solid Works to bender data then to connect Solid Works workstations to SVNET-based benders.
If a measuring center arm is setup to sketch a 3D centerline of a measured tube shape, then Benderlink will help you reverse-engineer tube shapes, and assist in correcting the bender's data.
Features
The main features of this software:
- - Read tube data from Solid Works
- - Convert the tube data to bender data
- - Save / Recall the bender data
- - Send new nominal data to benders that support SVNET protocol.
- - With a measureing center: Make and send correction data to benders that support the SVNET protocol.
- - With a measuring center: Reverse-engineer tube shapes
http://advancedtubular.com/blink_sw/help_html/clip0003.jpg
The reverse-engineering feature is performed by using 3D sketch with a measuring center - like a FARO arm. The tube centerline is sketched in 3D, then transferred to Benderlink for Solid Works.
The correction feature is performed by measuring a tube with FARO arm, using this data to create a tube centerline in Solid Works, then allow Benderlink to compare this inspected data with the MASTER data.
Demonstration Videos
Download and view videos that show how Benderlink for SolidWorks works.
- Introductory Demonstration Video: http://www.advancedtubular.com/blink_sw/Benderlink_for_SolidWorks_Intro.exe
Help
Read the help file here.
[1] Read the online help
--Mcone 13:37, 28 July 2006 (EDT)
