Communications Board for Eaton Leonard - CB-EL1

About

This is the Advanced Tubular Technologies communications board designed to communicate with all VELOG, EL-2000, and Premier controls.

• This board allows us to communicate with any of the three Eaton Leonard bender models using our Benderlink for Eaton Leonard software. This software is used for offline editing of all Eaton Leonard data, storage of Eaton Leonard data, and measuring center communications.
  
  

• We also use this board in our Benderlink Ethernet Module that allows wired or wireless communications using Ethernet protocols.
  
  

• We offer this board as a direct replacement to the boards in the Premier controls. (EL-2000 and Velogs have this electronics built-in to the computer boards.)
  
  

Vector 1 Laservision Side or Bender Side

• As of version 2 of this board, the board can be set using jumpers to operate on either side of the connection - either as a BENDER or as a MEASURING CENTER. This means that the board can be used to connect non-Eaton Leonard benders to Laservision using the standard legacy Eaton Leonard protocol.
  
  

• See this page for an example of how it can be used on the BENDER side of the connection: Benderlink Module - Laservision to Crown

Current Loop

The electronic protocol is referred to by Eaton Leonard as "current loop".

The protocol has been used for several decades and is still one of the standard ports provided on the Eaton Leonard measuring centers.

Features

There are several features and improvements in our design of this board:

1. The board requires only a single +5 volt power (The original design requires both +15 volt, -15 volt, and +5 volt power.)
2. The simplified electronic design allowed for size reduction to 1/3 original size or the standard EL boards.
3. This board includes LED indicators: Indicates power, transmission, and reception
4. This board includes built-in current reversal protection. Reversing the power polarity will not destroy the board.
5. This board uses screw terminals for power connection
6. The communications connectors are easy-to-use RJ45 receptacles
7. The board is certified RoHS compliant (no lead solder)

Communications Modes - LED Activity

The CB-EL1 includes LEDs (Light Emitting Diodes) are that critical for diagnosing issues with systems. This is how the board appears when a Benderlink package is strobing the RTS and is ready for communications.
This is how the LEDs appear data is being sent by the Vector to Benderlink. Note that the RX is flashing.

DataSheets

Download a Datasheet for the CB-EL1 board The datasheet contains the information found in this web page.

Purchase

We purchase these in batches - so if you purchase them in quantity, then we can give a batch discount. Of course, we're happy to sell them one at a time. Please contact Mike Cone ([email protected]) for batch-pricing information.