CNC Bender v12-20130805

v12-20130805 Back to CNC Bender Software Updates

See CNC Bender Customer Service Page for an update.

NEW: Swing-away Inside Wiper Logic

The new logic ensures that the swing-away inside wiper die swings away properly for a one bend part. The swing-away inside wiper will no longer move in before the carriage moves to the START position. It will only move in after the motion to the start position. If the START position is inside the wiper die zone, then the wiper die will swing in only if the next motion is to unchuck and move back out of the zone (for example on a one bend part).

NEW: "Store Jog Commands When In Cycle Hold" Option

A new low-level option is added that changes the behavior of motion-controlled Jog commands when the control is in Cycle Hold. The "Store Jog Commands When In Cycle Hold" command will allow the bender to store and act on any jog command that was pressed immediately after entering CYCLE START. If the feature is disabled, then CNC BENDER will not store motion-controlled jog commands - but will clear them from the queue.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands