CNC Bender v10-20070705
From ATTWiki
Contents |
REVISION Information
10-20070705, July 5, 2007
NEW: Low Level Option - Don't Warn if Skip Run Buttons
Experienced operators asked us to allow CNC Bender to warn when the SKIP RUN BUTTONS feature is enabled in the Pre-Bend Options page. This issue was addressed by inserting an Immediate Message warning and a Cycle Hold into the processlist if this condition exists.
If the option is ENABLED, then there is no warning if the Skip Run Buttons feature is enabled.
ENHANCED: Support for All Eight Programmable Limit Switches
CNC Bender can now support all eight Programmable Limit Switches for any motion-controlled axis.
Bender List
- SMT 19150 - Right Hand Electric MiiC Bender - Dual Radius Carriage Shifter
- SMT 19152 - Right Hand Electric Eagle Bender - Single Radius
- SMT 20118 - Left Hand Eagle Bender - Dual Radius Head Shifter
