Multi-Elongation in VTube
From ATTWiki
|
|
|
Multi-Elongation Percentage Compensation Setup
VTube allows each bend to have a unique tube elongation percentage - which is used to calculate correct CUT LENGTHS and UNBENDING LENGTHS
Use the popup menus in either the PART SETUP or the XYZ grids to get to the setup window.
A new checkbox is added at the bottom of Part Setup to allow this feature to be activated.
If the checkbox is unchecked, then the single Tube Elongation % value is used to calculate elongation for all bends.
Read More About Tube Elongation
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
