Difference between revisions of "CNC Bender v11-20090827"
From ATTWiki
| Line 8: | Line 8: | ||
In previous versions, "[CYCLEHOLD]" had no effect inside secondary processes that control devices around the bender. Now hoppers and side loaders can put the entire cell into the regular [[cycle hold]] state.<br><br> | In previous versions, "[CYCLEHOLD]" had no effect inside secondary processes that control devices around the bender. Now hoppers and side loaders can put the entire cell into the regular [[cycle hold]] state.<br><br> | ||
| + | This is a snippet from a secondary processlist. | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
<pre> | <pre> | ||
[Immediate_Message] AUTOLOADER PART NEST JAMMED - Entering CYCLE HOLD | [Immediate_Message] AUTOLOADER PART NEST JAMMED - Entering CYCLE HOLD | ||
[CYCLEHOLD] | [CYCLEHOLD] | ||
</pre> | </pre> | ||
| − | |||
| − | |||
| − | |||
===[[image:Check.jpg|25px]] ENHANCED - AutoLoader Timeout is Tied to Robot Timeout === | ===[[image:Check.jpg|25px]] ENHANCED - AutoLoader Timeout is Tied to Robot Timeout === | ||
Revision as of 15:32, 28 August 2009
NEW - CYCLE HOLD for Secondary Processes -
In previous versions, "[CYCLEHOLD]" had no effect inside secondary processes that control devices around the bender. Now hoppers and side loaders can put the entire cell into the regular cycle hold state.
This is a snippet from a secondary processlist.
[Immediate_Message] AUTOLOADER PART NEST JAMMED - Entering CYCLE HOLD [CYCLEHOLD]
ENHANCED - AutoLoader Timeout is Tied to Robot Timeout
The Robot Timeout value in the Low Level dynamic options is now used to control the AutoLoader timeouts.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See End Cycle Mode
