Difference between revisions of "CNC Bender v12-20110323"
From ATTWiki
| (3 intermediate revisions by one user not shown) | |||
| Line 22: | Line 22: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=400> | <td width=400> | ||
| + | [[image:vbh50_benders_closeup.jpg|300px]]<br><br> | ||
See a [http://www.youtube.com/watch?v=urQfTgRDrU8 YouTube video] for this bender. | See a [http://www.youtube.com/watch?v=urQfTgRDrU8 YouTube video] for this bender. | ||
| − | |||
| − | |||
<br><br> | <br><br> | ||
CNC Bender can now also be installed on manual hand benders. These are Eaton Leonard benders with bend arms that are pulled by hand. A brake engages when the bend arm comes into position. | CNC Bender can now also be installed on manual hand benders. These are Eaton Leonard benders with bend arms that are pulled by hand. A brake engages when the bend arm comes into position. | ||
| − | |||
| − | |||
</td> | </td> | ||
<td> | <td> | ||
| + | [[image:vbh50_benders_overall.jpg|300px]] | ||
</td> | </td> | ||
| Line 37: | Line 35: | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
| − | |||
| − | |||
===[[image:Check.jpg|25px]] NEW - SmartInspect Configuration File Added === | ===[[image:Check.jpg|25px]] NEW - SmartInspect Configuration File Added === | ||
| Line 47: | Line 43: | ||
A new configuration file "loggingsetup.cfg" is added to the cnc\config folder. | A new configuration file "loggingsetup.cfg" is added to the cnc\config folder. | ||
<br><br> | <br><br> | ||
| − | The new logging setup allows for debug logging in both CNC Processor and CNC Bender. | + | The new logging setup allows for debug logging in both CNC Processor and CNC Bender. |
<br><br> | <br><br> | ||
The logging setup features for CNC Processor were previously in the CNCProcessor.cfg file. | The logging setup features for CNC Processor were previously in the CNCProcessor.cfg file. | ||
Latest revision as of 12:12, 29 March 2011
v12-20110323
|
|
NEW - Logic for VBH50 Manual Hand Benders Added
|
|
|
NEW - SmartInspect Configuration File Added
|
A new configuration file "loggingsetup.cfg" is added to the cnc\config folder.
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
