Difference between revisions of "Multi-Elongation in VTube"
From ATTWiki
(→Multi-Elongation Percentage Compensation Setup) |
(→Multi-Elongation Percentage Compensation Setup) |
||
| Line 24: | Line 24: | ||
[[image:vtube_v2.2_partsetup_multielongationsetup_switch.png|300px]]<br><br> | [[image:vtube_v2.2_partsetup_multielongationsetup_switch.png|300px]]<br><br> | ||
If the checkbox is unchecked, then the single Tube Elongation % value is used to calculate elongation for all bends. | If the checkbox is unchecked, then the single Tube Elongation % value is used to calculate elongation for all bends. | ||
| + | |||
| + | |||
| + | ==Read More About Tube Elongation== | ||
| + | * About [[Tube Elongation Percentage in VTube]] | ||
| + | * [[How to Calculate Tube Elongation Percentage in VTube-LASER]] | ||
| + | |||
| + | <br><br> | ||
==Other Pages== | ==Other Pages== | ||
Revision as of 16:10, 1 June 2016
|
|
|
Multi-Elongation Percentage Compensation Setup
VTube allows each bend to have a unique tube elongation percentage - which is used to calculate correct CUT LENGTHS and UNBENDING LENGTHS
Use the popup menus in either the PART SETUP or the XYZ grids to get to the setup window.
A new checkbox is added at the bottom of Part Setup to allow this feature to be activated.
If the checkbox is unchecked, then the single Tube Elongation % value is used to calculate elongation for all bends.
Read More About Tube Elongation
- About Tube Elongation Percentage in VTube
- How to Calculate Tube Elongation Percentage in VTube-LASER
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
