Difference between revisions of "Multi-Elongation in VTube"
From ATTWiki
(Created page with "<table> <tr cellpadding=10> <td width=225> 200px 200px * Back to VTube-STEP * Back to [[VTube-LASER]...") |
(→Read More About Tube Elongation) |
||
| (3 intermediate revisions by one user not shown) | |||
| Line 16: | Line 16: | ||
__NOTOC__ | __NOTOC__ | ||
| − | == | + | ==Multi-Elongation Percentage Compensation Setup== |
| − | + | [[image:vtube_v2.2_multielongation_setup_window.png|400px|right]] | |
| − | + | VTube allows each bend to have a unique tube elongation percentage - which is used to calculate correct CUT LENGTHS and UNBENDING LENGTHS<br><br> | |
| − | + | ||
| − | VTube | + | |
Use the popup menus in either the PART SETUP or the XYZ grids to get to the setup window.<br><br> | Use the popup menus in either the PART SETUP or the XYZ grids to get to the setup window.<br><br> | ||
[[image:vtube_v2.2_XYZpopup_multielongationsetup.png|300px]]<br><br> | [[image:vtube_v2.2_XYZpopup_multielongationsetup.png|300px]]<br><br> | ||
| Line 26: | Line 24: | ||
[[image:vtube_v2.2_partsetup_multielongationsetup_switch.png|300px]]<br><br> | [[image:vtube_v2.2_partsetup_multielongationsetup_switch.png|300px]]<br><br> | ||
If the checkbox is unchecked, then the single Tube Elongation % value is used to calculate elongation for all bends. | If the checkbox is unchecked, then the single Tube Elongation % value is used to calculate elongation for all bends. | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| + | |||
| + | ==Read More About Tube Elongation== | ||
| + | * About [[Tube Elongation Percentage]] | ||
| + | * [[How to Calculate Tube Elongation Percentage in VTube-LASER]] | ||
| + | |||
| + | <br><br> | ||
==Other Pages== | ==Other Pages== | ||
Latest revision as of 16:11, 1 June 2016
|
|
|
Multi-Elongation Percentage Compensation Setup
VTube allows each bend to have a unique tube elongation percentage - which is used to calculate correct CUT LENGTHS and UNBENDING LENGTHS
Use the popup menus in either the PART SETUP or the XYZ grids to get to the setup window.
A new checkbox is added at the bottom of Part Setup to allow this feature to be activated.
If the checkbox is unchecked, then the single Tube Elongation % value is used to calculate elongation for all bends.
Read More About Tube Elongation
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
