Difference between revisions of "Building Tube Assemblies in SOLIDWORKS"
From ATTWiki
(→STEP 1: Measure the Part in VTube-LASER) |
|||
| Line 19: | Line 19: | ||
| − | ==STEP 1: Measure the | + | ==STEP 1: Measure One of the Parts in VTube-LASER== |
[[image:vtube-laser_v2.5_measure header pipe.png|500px]]<br><br> | [[image:vtube-laser_v2.5_measure header pipe.png|500px]]<br><br> | ||
Without moving the assembly, measure the first pipe, then use the File tab in Measure Tube Data to send the measured part to SOLIDWORKS. | Without moving the assembly, measure the first pipe, then use the File tab in Measure Tube Data to send the measured part to SOLIDWORKS. | ||
Revision as of 18:52, 2 June 2016
|
|
|
VTube-LASER can reverse engineer tube and then build that tube in SOLIDWORKS as a fully-constrained 3D parametric model. This page describes the basic steps to create an assembly from a part using VTube-LASER and SOLIDWORKS.
STEP 1: Measure One of the Parts in VTube-LASER
Without moving the assembly, measure the first pipe, then use the File tab in Measure Tube Data to send the measured part to SOLIDWORKS.
Read More About Tube Elongation
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
