Difference between revisions of "Building Tube Assemblies in SOLIDWORKS"
From ATTWiki
(→STEP 1: Measure the Part in VTube-LASER) |
(→STEP 1: Measure One of the Parts in VTube-LASER) |
||
| Line 21: | Line 21: | ||
==STEP 1: Measure One of the Parts in VTube-LASER== | ==STEP 1: Measure One of the Parts in VTube-LASER== | ||
[[image:vtube-laser_v2.5_measure header pipe.png|500px]]<br><br> | [[image:vtube-laser_v2.5_measure header pipe.png|500px]]<br><br> | ||
| − | + | Measure the first pipe and create a measured tube shape. | |
| + | <br><br> | ||
| + | |||
| + | ==STEP 2: Build the Part in SOLIDWORKS== | ||
| + | [[image:vtube-laser_v2.5_build solidworks.png|500px]]<br><br> | ||
| + | Use the File tab in Measure Tube Data to send the measured part to SOLIDWORKS. | ||
<br><br> | <br><br> | ||
Revision as of 18:54, 2 June 2016
|
|
|
VTube-LASER can reverse engineer tube and then build that tube in SOLIDWORKS as a fully-constrained 3D parametric model. This page describes the basic steps to create an assembly from a part using VTube-LASER and SOLIDWORKS.
STEP 1: Measure One of the Parts in VTube-LASER
Measure the first pipe and create a measured tube shape.
STEP 2: Build the Part in SOLIDWORKS
Use the File tab in Measure Tube Data to send the measured part to SOLIDWORKS.
Read More About Tube Elongation
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
