Difference between revisions of "Building Tube Assemblies in SOLIDWORKS"
From ATTWiki
(→STEP 3: Save the SOLIDWORKS Part File) |
(→STEP 4: Repeat Steps 1 through 3 for all the parts) |
||
| Line 35: | Line 35: | ||
==STEP 4: Repeat Steps 1 through 3 for all the parts== | ==STEP 4: Repeat Steps 1 through 3 for all the parts== | ||
Be careful to not move the assembly. Repeat the first three steps for each tube.<br><br> | Be careful to not move the assembly. Repeat the first three steps for each tube.<br><br> | ||
| + | |||
| + | ==STEP 5: Start a New Assembly== | ||
| + | Start a new assembly. These steps show how to insert four parts from the SOLIDWORKS part files.<br><br> | ||
| + | [[image:vtube-laser_v2.5_solidworks new assembly.png|500px]] | ||
==Read More About Tube Elongation== | ==Read More About Tube Elongation== | ||
Revision as of 19:32, 2 June 2016
|
|
|
VTube-LASER can reverse engineer tube and then build that tube in SOLIDWORKS as a fully-constrained 3D parametric model. This page describes the basic steps to create an assembly from a part using VTube-LASER and SOLIDWORKS.
STEP 1: Measure One of the Parts in VTube-LASER
Measure the first pipe and create a measured tube shape.
STEP 2: Build the Part in SOLIDWORKS
Use the File tab in Measure Tube Data to send the measured part to SOLIDWORKS.
STEP 3: Save the SOLIDWORKS Part File
Save the part to a unique SOLIDWORKS part file on the disk.
STEP 4: Repeat Steps 1 through 3 for all the parts
Be careful to not move the assembly. Repeat the first three steps for each tube.
STEP 5: Start a New Assembly
Start a new assembly. These steps show how to insert four parts from the SOLIDWORKS part files.
Read More About Tube Elongation
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
