Difference between revisions of "VTube-LASER Training Agenda"
From ATTWiki
(→Day 1) |
(→Typical Training Agenda) |
||
| Line 34: | Line 34: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300 > | <td width=300 > | ||
| − | |||
=== Day 1 === | === Day 1 === | ||
| Line 40: | Line 39: | ||
2 - Bender integration assistance (Note: Steps one and 2 may take a few hours)<br><br> | 2 - Bender integration assistance (Note: Steps one and 2 may take a few hours)<br><br> | ||
3 - Probe and scanner calibration<br><br> | 3 - Probe and scanner calibration<br><br> | ||
| − | 4 - Step through the Quick Start Guide document<br><br> | + | 4 - Step through the [https://www.advancedtubular.com/customers/vtube/VTube-LASER%20Version%202.8.4%20-%20VTube-LASER%20Quick%20Start%20Guide.pdf Quick Start Guide] document<br><br> |
5 - Hands-on practice for students<br><br> | 5 - Hands-on practice for students<br><br> | ||
6 - Address any unique application needs - like using the ball probe, reverse engineering, assembly, measuring square tubing, etc. <br><br> | 6 - Address any unique application needs - like using the ball probe, reverse engineering, assembly, measuring square tubing, etc. <br><br> | ||
Revision as of 16:39, 7 September 2017
|
|
|
Contents |
About theTraining Agenda
|
Training agendas for VTube-LASER usually follow the pattern shown below. |
Typical Training Agenda
Day 11 - Arm installation and setup Day 21 - Review what we learned on day 1 - quiz the students |
Other Pages
- Back to VTube-LASER
