Difference between revisions of "VTube-LASER Training Agenda"

Revision as of 16:02, 28 September 2017

Training agendas for VTube-LASER usually follow the pattern shown below.

We often adjust the training depending on the customer's application needs.

STEP	INSTALLATION / TRAINING TASK
1	Arm installation and setup
2	Bender integration assistance
3	Probe and scanner calibration
4	Setup a program from solid model
5	How to setup a program from a print
6	Arm connection and scanner setup
7	Measuring Cut Planes (measuring the table surface)
8	General measuring setup (set your default tolerances into VTube-LASER)
9	How to measuring the tube/pipe
10	Understanding the inspection results to qualify the tube shape
11	Using BENDER SETUP to connect to benders for setup and correction
12	How to view reports
13	How to reverse-engineer a tube
14	Address any unique application needs
15	Hands-on practice for students

STEP	INSTALLATION / TRAINING TASK
1	Review what we learned on day 1 - quiz the trainees
2	Practice full corrections loops with actual customer parts
3	Review special application needs

@@ Line 21: / Line 21: @@
 <td width=500 >
 Training agendas for VTube-LASER usually follow the pattern shown below.<br><br>
-Keep in mind that we adjust the training depending on the customer's application needs. So the agenda shown below may be adjusted if necessary.
+We often adjust the training depending on the customer's application needs.
 <br><br>