Difference between revisions of "VTube-LASER v2.9"
(→25px NEW: END POINT DIMENSION) |
(→25px ENHANCED: END SCAN ANALYSIS MUCH IMPROVED) |
||
| Line 57: | Line 57: | ||
</table> | </table> | ||
| − | ==[[image:Check.jpg|25px]] ENHANCED: END SCAN | + | ==[[image:Check.jpg|25px]] ENHANCED: END SCAN PLACEMENT IS MUCH IMPROVED== |
<table cellpadding=10 width=1100> | <table cellpadding=10 width=1100> | ||
Revision as of 20:42, 27 October 2017
|
Revision 2.9Original Release Date: November 1, 2017
|
|
NEW - ASSEMBLY
|
VTube now allows you to include multiple tubes in a single project.
|
ENHANCED - Bender Number Saved and Recalled with Project File
|
VTube now saves the Bender Setup bender number to the project file.
|
ENHANCED: END SCAN PLACEMENT IS MUCH IMPROVED
|
The end scan algorithm in version 2.9 much faster than previous versions and is it also much better at finding the correct furthest point in the scan. This makes end scans much easier. |
NEW: END POINT DIMENSION
|
VTube now automatically draws a linear dimension in the viewport between the scanned point and the final offset point to confirm that the distance is correct. |
|
NEW: SEARCH AND MOVE IN PATH MANAGER
|
VTube now lets you search for path names in the Path Manager. |
|
BUILD 1 - REMOVED "Move Arm from Cradle" MESSAGE
|
This message appeared when loading VTube-LASER projects on older arms. This message is no longer displayed because it is not needed with then newer FARO drivers. |
BUILD 1 - CTRL-S SAVES THE PROJECT THEN BRINGS LASER WINDOW TO THE FRONT
|
This fixes an issue where the Ctrl-S would bring the STEP mode window to the foreground when saving VTube-LASER projects. Now the VTube-LASER window moves back to the top after the save. |
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
