Difference between revisions of "VTube-LASER v2.9.2"
From ATTWiki
(Created page with "<table> <tr cellpadding=10> <td width=225> 300px ==Revision 2.9.2 Build 104== Release Date: December 1, 2017<br> * Back to VTube-LASER...") |
|||
Line 23: | Line 23: | ||
__NOTOC__ | __NOTOC__ | ||
− | ==[[image:Check.jpg|25px]] | + | ==[[image:Check.jpg|25px]]FIXED and IMPROVED - Split Bend - Finding Surface Edges== |
− | <table cellpadding=10 width= | + | <table cellpadding=10 width=800> |
<tr valign=top> | <tr valign=top> | ||
+ | |||
<td width=300> | <td width=300> | ||
− | + | As of version 2.9, the Split Bend logic would not find the exact outside of the apex of the surface diameters in 180-degree bends.<br><br>At best, the split bend centerline would be 0.020" off from the original.<br><br> | |
− | + | <b>In addition to the fix, the logic has been improved to be faster and more reliable than in any previous version.</b> | |
− | < | + | |
</td> | </td> | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
<td> | <td> | ||
− | [[image: | + | [[image:splitbend_before_fix.png|500px]]<br><br> |
+ | [[image:splitbend_after_fix.png|500px]]<br> | ||
</td> | </td> | ||
</tr> | </tr> | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
</table> | </table> | ||
<br><br> | <br><br> |
Revision as of 21:50, 1 December 2017
Revision 2.9.2 Build 104Release Date: December 1, 2017
|
FIXED and IMPROVED - Split Bend - Finding Surface Edges
As of version 2.9, the Split Bend logic would not find the exact outside of the apex of the surface diameters in 180-degree bends. |
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature