Difference between revisions of "VTube-LASER v2.9.2"
From ATTWiki
(→25pxFIXED and IMPROVED - Split Bend - Finding Surface Edges) |
|||
| Line 31: | Line 31: | ||
As of version 2.9, the Split Bend logic would not find the exact outside of the apex of the surface diameters in 180-degree bends.<br><br>At best, the split bend centerline would be 0.020" off from the original.<br><br> | As of version 2.9, the Split Bend logic would not find the exact outside of the apex of the surface diameters in 180-degree bends.<br><br>At best, the split bend centerline would be 0.020" off from the original.<br><br> | ||
<b>In addition to the fix, the logic has been improved to be faster and more reliable than in any previous version.</b> | <b>In addition to the fix, the logic has been improved to be faster and more reliable than in any previous version.</b> | ||
| + | </td> | ||
| + | |||
| + | <td> | ||
| + | [[image:splitbend_before_fix.png|500px]]<br><br> | ||
| + | [[image:splitbend_after_fix.png|500px]]<br> | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | </table> | ||
| + | <br><br> | ||
| + | |||
| + | |||
| + | ==[[image:Check.jpg|25px]]FIXED and IMPROVED - Bend Profile== | ||
| + | |||
| + | <table cellpadding=10 width=800> | ||
| + | <tr valign=top> | ||
| + | |||
| + | <td width=300> | ||
| + | The same issues that affected the Split Bend logic also affected the Bend Profile logic.<br><br>This has been repaired in this version. | ||
</td> | </td> | ||
Revision as of 21:52, 1 December 2017
|
Revision 2.9.2 Build 104Release Date: December 1, 2017
|
|
FIXED and IMPROVED - Split Bend - Finding Surface Edges
|
As of version 2.9, the Split Bend logic would not find the exact outside of the apex of the surface diameters in 180-degree bends. |
|
FIXED and IMPROVED - Bend Profile
|
The same issues that affected the Split Bend logic also affected the Bend Profile logic. |
|
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
