Difference between revisions of "VTube-LASER v2.9.10"
(→25pxNEW - LASER SCAN FILTER SOUND) |
(→25pxNEW - LASER SCAN FILTER SOUND) |
||
| Line 26: | Line 26: | ||
==[[image:Check.jpg|25px]]NEW - LASER SCAN FILTER SOUND== | ==[[image:Check.jpg|25px]]NEW - LASER SCAN FILTER SOUND== | ||
| − | <table cellpadding=10 width= | + | <table cellpadding=10 width=1200> |
<tr valign=top> | <tr valign=top> | ||
<td width=400> | <td width=400> | ||
| − | In previous versions of VTube-LASER, the scanning sound goes silent if no scan data | + | In previous versions of VTube-LASER, the scanning sound goes silent if the SCAN BUTTON is pressed and no scan data entering VTube-LASER.<br><br> |
| − | In this version, if the scanned data is removed by the filter, or no data is incoming because the scanner is out of range, then the LASER SCAN FILTER sound will play. | + | In this version, if the scan button is pressed and all scanned data is removed by the filter, or no data is incoming because the scanner is out of range, then the LASER SCAN FILTER sound will play. |
</td> | </td> | ||
Revision as of 22:03, 4 July 2018
|
Revision 2.9.10Release Date: July 1, 2018
|
|
Contents |
NEW - LASER SCAN FILTER SOUND
|
In previous versions of VTube-LASER, the scanning sound goes silent if the SCAN BUTTON is pressed and no scan data entering VTube-LASER. |
Video 86: VTube-LASER's LASER SCAN FILTER SOUNDThis is a short video that shows how the Laser Scan Filter sound helps you know when all laser scan data is removed by the scan filters.
|
NEW - PRESS ACCEPT BUTTON WITHOUT AIMING AT THE PART
|
VTube-LASER operators know that previous versions of VTube-LASER require that you aim the LASER scanner at the part when you press the accept button at the end of a scan.
We have redesigned the scanning engine so it no longer requires this in-range scanning position. |
|
NEW - HERBER Bender Corrections Through a Network
|
We added and tested HERBER MES file correction support that allows VTube-LASER to correct HERBER benders through a network connection automatically.
|
|
NEW - HERBER Bender Setup From Solid Model Through a Network
|
We added the HERBER SOL file protocol that allows VTube-LASER to send NEW data to the HERBER benders through a network connection.
|
|
OTHER CHANGES
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
