Difference between revisions of "VTube-LASER v2.9.12"
From ATTWiki
(Created page with "<table> <tr cellpadding=10> <td width=225> 300px ==Revision 2.9.12== Release Date: Unreleased<br> Current Build: 1 * Back to VTube-LAS...") |
(→25pxFIX - BENDER SETUP WINDOW DRAW TO REDUCED MONITOR COUNT) |
||
| Line 24: | Line 24: | ||
__TOC__ | __TOC__ | ||
| − | ==[[image:Check.jpg|25px]]FIX - BENDER SETUP WINDOW | + | ==[[image:Check.jpg|25px]]FIX - BENDER SETUP WINDOW DISPLAY ON REDUCED MONITOR COUNT == |
<table cellpadding=10 width=800> | <table cellpadding=10 width=800> | ||
| Line 44: | Line 44: | ||
</table> | </table> | ||
<br><br> | <br><br> | ||
| − | |||
=Other Pages= | =Other Pages= | ||
Revision as of 04:05, 26 July 2018
|
Revision 2.9.12Release Date: Unreleased
|
|
Contents |
FIX - BENDER SETUP WINDOW DISPLAY ON REDUCED MONITOR COUNT
|
The Bender Setup window could improperly attempt to display on a monitor that was available, but is now no longer available. This has been resolved.
|
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
