Difference between revisions of "VTube-LASER v2.9.12"
(→25px OTHER CHANGES) |
(→25pxNEW LRA POPUP MENU SPLITS ONE BEND INTO TWO) |
||
| Line 30: | Line 30: | ||
<td width=300> | <td width=300> | ||
| + | The USAF asked us to add a feature that allowed for splitting a very sharp-angled bend into two adjacent half-bends.<br><br> | ||
| − | + | This is useful for when a very high bend angle throws its intersection point far from the tube and then creates unreliably high swings in the tangent deviation and bender correction data.<br><br> | |
| − | This is | + | Use this new feature with the SPLIT BEND measuring feature to overcome this problem like this:<br><br> |
| − | + | ||
1 - Select the bend to split in an LRA grid.<br><br> | 1 - Select the bend to split in an LRA grid.<br><br> | ||
Revision as of 23:51, 10 August 2018
|
Revision 2.9.12Release Date: August 13, 2018
|
|
Contents |
NEW LRA POPUP MENU SPLITS ONE BEND INTO TWO
|
The USAF asked us to add a feature that allowed for splitting a very sharp-angled bend into two adjacent half-bends. This is useful for when a very high bend angle throws its intersection point far from the tube and then creates unreliably high swings in the tangent deviation and bender correction data. 1 - Select the bend to split in an LRA grid. |
|
OTHER CHANGES
|
|
Other Pages
- See VTube-LASER Addata ZModem Communications Protocol for more information.
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See the tutorial on DCF - Dual Cylinder Fit
- See the tutorial on DCP - Diameter Cut Planes
- See VTube-LASER Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
